Für eine deutsche Übersetzung Klicken Sie hier
For more information about the product follow the respective links:
Quick start.
Getting your Solar Outdoor Siren 2 up and running is as simple as installing it and linking it to your Z-Wave network. The following instructions tell you how to add your Solar Outdoor Siren 2 to your Z-Wave network using an existing gateway.
Installation and mounting of Siren:
- Mount the back mounting plate using 4 screws (we recommend to mount the back mounting plate 5 mm from the wall for better sound).
- Open the case and turn on the power switch (see illustration below) by moving it towards the Z-Wave button (B). All LEDs will shine for a short moment to confirm.
- Remove the metal mounting plate from the device.
- Remove all protection foil from the device.
- Now it is time to install Solar Outdoor Siren 2 to your existing gateway in the upcoming section.
Using an existing gateway:
- Place your gateway or controller into Z-Wave pair or inclusion mode. (Please refer to your controller/gateway manual on how to do this)
- Tap the internal button on Outdoor Solar Siren 2 once.
- Your gateway should confirm if Solar Outdoor Siren 2 is successfully included into your network.
- Now close up your Solar Outdoor Siren 2 by screwing in 6 screws to the mounting plate.
- As soon as Outdoor Siren 2 is mounted, the tamper switch will activate. You should not remove the Siren from its mount to avoid triggering a tamper alarm.