Nicht Ihre Sprache: Klicken Sie hier für deutsch
Manual override
The switch Dimmer terminal reserves the access of manual override function for the end-user to switch on/off, or adjust the light level by push-switch.
- Short Push (<1s): permanent on/off function.
- Long Push (>1s): adjust the brightness level.
Notes:
- Both the adjustment on App and push switch can overwrite each other, the last adjustment remains in memory.
- App control is synchronized with the manual switch.
- The “S” terminals may be left unconnected if no manual control is required
Installation:
WARNING:
- Installation must be carried out by a qualified electrician in accordance with local regulations.
- Keep the device out of reach of children.
- Keep the device away from water, damp or hot environment.
- Install the device away from strong signal sources such as microwave oven that may cause signal interruption resulted to abnormal operation of the device.
- Obstruction by concrete wall or metallic materials may reduce the effective operation range of the device and should be avoided.
- Do NOT attempt to disassemble, repair or modify the device.
Wiring Instructions and Diagrams
- Turn off the power supply before carrying out any electrical installation work.
- Connect wires according to the wiring diagram.
- Insert the module into the junction box.
- Turn on the power supply and follow switch module configuration instructions.
Without Switch:
Single Control:
Double Switch:
Pairing:
- Start learning mode on your gateway/hub
- Press and hold the button for 10 Seconds to reset the device and starting learning mode.
Factory reset:
- Press and hold the button for 10 Seconds to reset the device.
- Press the external button 5 times for reset.
Technical Specifications:
- Voltage: 100-240 V AC 50/60Hz
- Max Load:
- LED 150W (230V)
- Operation Temp.: -10°C- 40°C
- Wireless Protocol: Zigbee 3.0
- Operation Range: <100m
- IP Rating: IP20