Für eine deutsche Übersetzung Klicken Sie hier


For more information about the product follow the respective links:




Precautions

  • Be careful that no liquid gets into the smart cable since it may damage the equipment. 
  • Do not remove the product label as it contains important information. 
  • Avoid switching maximum loads frequently on or off, in order to sustain a long life for the smart cable.


Installation

Safety Warning for Mains Powered Devices

ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the assembly of the product, the voltage network has to be switched off and ensured against re-switching.

  1. Unscrew the inner four screws on the back of the device. 
  2. Open the casing by pushing the fastening on both sides with a flathead screwdriver.
  3. Cut your cord in half with wire strippers, remove about 25 mm of the insulation from both ends of the cable freeing the three wires. Remove about 5 mm of the insulation from these three wires on both ends of the cable.
  4. Run the exposed cable underneath the clamps and insert the correct wires into the correct ports (Live to Live, Ground to Ground, Neutral to Neutral). Secure the wires by tightening the screws.
  5. Attach the cable running to the appliance to the ”LOAD” ports and the end which runs to the outlet into the ”IN”  ports)
  6. With the wires secured, tighten the screws of the cable clamps to secure the cable.
  7. Replace the top of the device and tighten in the four inner screws to close the casing. 
  8. Ensure that the cables are securely fastened. 


Join to Network

  1. Connect the Smart Cable to the power outlet.
  2. The Smart Cable will start searching (up to15 minutes) for a Zigbee network to join.
  3. Make sure that the Zigbee network is open for joining devices and will accept the Smart Cable.
  4. While searching for a network, the red LED is flashing every second.
  5. The Smart Cable’s output is active when the green LED is on.


Placement

  • Place the smart cable indoors at a temperature between 0-50°C. 
  • If the device is used as a signal amplifier, please position the device in between the gateway and other connected devices.


Modes

  • SEARCHING GATEWAY MODE - The red LED is flashing every second 
  • ON MODE - Green LED means that the smart cable output is active (relay is on). The relay can be switched on and off by pushing the button. 
  • OFF MODE - When there is no light in the LED, the Smart Cable output is inactive.


Reset the Device


Resetting is needed if you want to connect your Smart Cable to another gateway, if you need to perform a factory reset to remove abnormal behavior, or if you need to reset accumulative registers and logs.

  1. Connect the Smart Cable to the power outlet.
  2. Press and hold down the button on the device. 
  3. Hold the button down until the red LED flashes continuously, then release the button.
  4. After releasing the button, the red LED will stay on for 2-5 seconds. During that time, the device must not be switched off or unplugged.


Fault finding & cleaning

  • In case of a bad or weak signal, change the location of the Smart Cable or your gateway.
  • If the search for a gateway has timed out, a short press on the LED button will restart it.


Specifications

  • Dimensions: (W x D x H) 108 x 36 x 24 mm
  • Color: White
  • IP class: IP30
  • Power Supply: 230V +/- 10%
  • Power consumption: 0,4 W
  • Reported resolution: 1 W
  • Max. switch current: 16 A
  • Operation temperature: 0 to +50°C
  • Relative humidity: 5% to 85% non-condensing
  • Wireless protocol: Zigbee 1.2
  • Router: Yes