Für eine deutsche Übersetzung Klicken Sie hier


For more information about the product follow the respective links:



Installation


DANGER OF ELECTROCUTION BEFORE ANY INSTALLATION MAKE SURE THE POWER SUPPLY IS DISCONNECTED TO AVOID ANY RISK OF ELECTROCUTION. Directly cut the power supply from the breaker box to avoid any risk of electrocution. This relay switch is designed to be used power-up, a wrong installation can create a fire or an electric shock. If you are not confident about electrical installation, please ask a professional. The relay switch must be installed and connected carefully following the instructions of this user guide. We will not be responsible for any loss or damage resulting from a non-respect of the instructions of this user guide. Cut the power supply before any operation and don’t do any modification if the LED is still ON.


RELAY SWITCH INPUT/OUTPUT 


Each terminal should be installed with a cable from 1.5mm² to 4mm² maximum, stripped of 8mm.


INSTALLATION DIAGRAM 



  1. Cut the power supply. 
  2. Disassemble the wired wall switch which controls the roller shutter/awning you want to connect. 
  3. Wire the Relay Switch according to the diagram figure 1.
  4. Reassemble the wired wall switch.
  5. Turn the power back ON.


AUTO-DETECTION OF SWITCH TYPE 

After turning the power supply ON, do a single push on the wired wall switch to bring the roller shutter half-height. The Relay Switch has an auto-detection system to automatically detect the type of wired wall switch (rocker or push-button) wired at the input.


Calibration of the Roller Shutter 


  1. Make sure that the shutter is in the bottom position.
  2. Press the button 5 times
  3. The roller shutter/awning confirms the auto-calibration by performing a complete cycle ”up/down/up


Join to Zigbee Network


  • When power is turned ON, the relay switch LED will blink orange, looking to join a Zigbee network. Go to your Zigbee gateway app to activate the relay switch detection.
  • If the relay switch has correctly joined the network, the LED becomes green. The relay switch is ready for use.
  • If the relay switch hasn’t joined a network within 15 minutes, the LED becomes orange. Do a brief press on the relay switch button and start again.


Reset & Remove from Zigbee Network

  1. Press more than 5 seconds on your module’s button. The LED blinks orange. 
  2. Press the button again (short press) to validate the reset. If the reset is successful, the LED flashes red and green alternately, then flashes orange. Repeat if necessary. 
  3. Your module has returned to its original configuration and is ready to join a new Zigbee network.