Smart Plug Mini 2 - FRIZSPLZB-141

Für eine deutsche Übersetzung Klicken Sie hier

For more information about the product follow the respective links:

• Extended User Guide
• Multilanguage User Guide

Precautions 

• Do not remove the product label as it contains important information. 
• Avoid switching maximum loads frequently on or off, in order to sustain a long life for the Smart Plug . 
• Be careful that no liquid gets into the Smart Plug since it may damage the equipment. 
• If the device is used as signal amplifier, please position the device in between the central device and the sensor(s). 

Join your Network

1. Connect the Smart Plug Mini to the power outlet. 
2. The Smart Plug Mini will now start searching (up to 15 minutes) for a Zigbee network to join. 
3. Make sure that the Zigbee network is open for joining devices and will accept the Smart Plug Mini. 
4. While the Smart Plug Mini is searching for the network, the LED button is flashing red
5. When the LED button stops flashing, the Smart Plug Mini has successfully joined the Zigbee network. 

Placement 

• Place the Smart Plug indoors at a temperature between 0-50°C. 
• If the device is used as signal amplifier, please position the device in between the central device and the sensor(s).

Reset your device

Resetting is needed if you want to connect your Smart Plug Mini to another gateway, if you need to perform a factory reset to remove abnormal behavior, or if you need to reset accumulative registers and logs. 

1. Connect the Smart Plug Mini to the power outlet. 
2. Press and hold down the button on the device. 
3. Hold the button down until the red LED flashes continuously, then release the button.
4. After releasing the button, the red LED will stay on for 2-5 seconds. During that time, the device must not be switched off or unplugged.  

Modes

• SEARCHING GATEWAY MODE - A red LED is flashing every second
• NORMAL MODE -  Green LED means that the Smart Plug output is active (relay is on). The relay can be switched on and off by pushing the LED button. 
• OFF MODE -  When there is no light in the LED button, it means that the relay is off (there is no output). The relay can be switched on and off by pushing the LED button.

Fault finding

• In case of power failure, the device will restore itself to the on/off status it had before the power failure. 
• In case of a bad or weak signal, change the location of the Smart Plug Mini or your gateway. 
• If the search for a gateway has timed out, a short press on the LED button will restart it.

Specifications

• Frequency: Zigbee
• Dimensions: Type E/F Ø41 X 45 mm
• Color: White
• Power supply: 230V +/-10%
• Power consumption: 0.4 W
• Operation temperature: 0 to +50°C
• Relative humidity: 5% - 85%, non condensing
• Max. switch voltage: 250 VAC
• Max. load: 16 A
• Max. continuous load: 10 A