Heiman Zigbee Gas Detector - HEIZHS1CG

Modified on Tue, 31 Jan, 2023 at 11:06 AM

Für eine deutsche Übersetzung Klicken Sie hier

Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.

Installation

Liquid gas:

The sensor should be installed at a height of 0.3-1m from the ground and at a distance of less than 1.5m from the gas source.

Natural gas, industrial gas, sump gas, etc.:

The sensor should be installed at a distance of 0.3-1 m from the ceiling, and with a distance to the gas source of less than 1.5 m.

Product usage

Shell surface will be slightly hot while working, which is normal phenomenon
Please dismantle sensor while decorating house
Avoid spraying aerosol around sensor
Oil adhension around gas convection holes may effect the sensitivity of gas sensor after long time of use. It‘s suggested to clear gas convection holes every 3 months (with little detergent, but with care so it doesn‘t enter the body of the sensor).
Semi-conductor of gas sensor has 5-year lifespan
Don‘t use lighter to test the sensor directly

Starting up

The green LED lights up after power on the sensor, when a beep sounds once, the sensor enters into warm-up state then red and yellow LED flashes alternately. Eventually, the flash stops 3 minutes later, which indicates that the sensor has entered into a normal working state.

LIGHT STATE & PRODUCT TEST

STATE	COLOR	LIGHT	ALARM SOUND
Power	Green	Normally on	No
Alarm	Red	Flashing	gas alarm
Malfunction	Yellow	Normally on	Long buzz

Test button of this sensor is used for testing weather LED indicator and buzzer can work properly. Red LED and yellow LED flash alternatively with buzzer alarm when the test button is pressed.

ZIGBEE

Connect to a gateway

Start the learning mode on your Zigbee gateway
Press the network button for 5 seconds -> the green LED flashes quickly

Device reset

Press the network button for 5 seconds -> the green LED flashes quickly

Technical data:

Working voltage	AC100V~240V Type C
Average power consumption	＜1.5W
Alarm sound	75dB/1m
Alarm density	6%LEL±3%LEL（natural gas）
Networking	Zigbee Ad-hoc Network
Wireless networking distance	≤100m(in open area)
Working environment	-10℃~+50℃
Environment humidity	Max ≤95%RH
Dimension	796831mm(no including plug)