Für eine deutsche Übersetzung Klicken Sie hier

For more information about the product follow the respective links:



Precautions

  • WARNING: For safety reasons, it is recommended that the equipment is installed in a way that makes it impossible to reach or touch the terminal blocks by accident. The best way to make a safe installation is to install the unit in an enclosure. Further, access to the equipment should be limited through the use of a lock and key, controlled by qualified electrical personnel.
  • The Smart DIN Relay must always be protected by fuses on the incoming side.

  • Be careful that no liquid gets into the Smart DIN Relay since it may damage the equipment.

  • Do not remove the product label as it contains important information.

  • Avoid switching maximum loads frequently on or off, in order to sustain a long life.


Safety Warning for Mains Powered Devices

ATTENTION: only authorized technicians under consideration of the country-specific installation guidelines/norms may do works with mains power. Prior to the assembly of the product, the voltage network has to be switched off and ensured against re-switching.


 Installation: 

  1. Disconnect the main power. For the duration of electrical work, electricity must be disconnected from the main switch of the property by removing the fuses for the work area.
  2. Place the Smart DIN Relay on the DIN rail and make sure it snaps onto it.
  3. Strip the cable insulation to 5 mm.
  4. Connect appropriate cables as shown in the section “Wiring diagram” and tighten the screws (0.8 Nm).
  5. Turn on the main power.
  6. The Smart DIN Relay will now start searching (up to 15 minutes) for a Zigbee network to join
  7. Make sure that the Zigbee network is open for joining devices and will accept the Smart DIN Relay.
  8. While the Smart DIN Relay is searching for a network, the LED is flashing red.
  9. When the LED stops flashing, the Smart DIN Relay has successfully joined the Zigbee network.
  10. The Smart DIN Relay’s output is active when the green LED is on.


Wiring





Modes

  • SEARCHING GATEWAY MODE:  The red LED flashes
  • ON MODE: Green LED means that the Smart DIN Relay output is active (relay is on). The relay can be switched on and off by pushing the button.
  • OFF MODE: When there is no light in the LED, the Smart DIN Relay output is inactive.


Resetting


Resetting is needed if you want to connect your Smart DIN Relay to another gateway, if you need to perform a factory reset to remove abnormal behavior, or if you need to reset accumulative registers and logs.


  1. Press and hold the menu button on the device
  2. Hold the button down until the red LED flashes continuously, then release the button.
  3. After releasing the button, the red LED will stay on for 2 - 5 seconds. During that time, the device must not be switched off or unplugged.


Fault finding and cleaning

  • In case of a bad or weak signal, change the location of your gateway or insert a Zigbee router as a range extender.

  • If the search for a gateway has timed out, a short press on the button will restart it.


Specifications 


  • Dimensions: 90 x 65 x 17.5 mm (332)
  • Color: Grey (332) White (342)
  • IP class: IP20
  • Power Supply: 230V +/- 10%
  • Power consumption: 0,4 W
  • Operation temperature: 0 to +50°C
  • Wireless protocol: Zigbee 3.0 Mesh
  • Router: Yes
  • Max. switch voltage: 250 VAC
  • Max. switch current: 16 A